Air Pump

Air Pump

Air Pump



Disable Air Pump on Decel - When this is ticked, the air pump will be disabled when the car is decellerating

Idle Delay - The amount of time used to allow idle to stabilise before the air pump increases the load on the engine

Hysteresis - The amount of time after the enable conditions are met, before the air pump will be enabled.

Min RPM - The minimum RPM required to enable the air pump

Max RPM - The maximum RPM allowed to keep the air pump enabled. RPM above this will disable the air pump.

Max Load - The maximum Load allowed to keep the air pump enabled. Load values above this will disable the air pump.
    • Related Articles

    • Fuel Pump (Wiring)

      The Orange/Blue wire is used to operate the fuel pump. When the Haltech ECU wants to operate the fuel pump it will close the fuel pump relay, which will supply the fuel pump with 12V from the Battery. It is important that the fuel pump is capable of ...
    • Transient Throttle (Throttle Pump) Explained

      In this article we are unravelling one of the mysteries of tuning; the often talked about but rarely understood dark art of tuning the Throttle Pump, or as we call it here at Haltech the Transient Throttle Enrichment function. Transient Throttle If ...
    • Air Pump

      This Function controls the Air Pump. Wiring Tab Connections Air Pump Output Active State Air Pump Tab Disable Air Pump on Decel Idle Delay Hysteresis Min RPM Max RPM Max Load Wiring Tab Connections Air Pump Output Select an available output wire, ...
    • Air Pump Wiring

      Wiring Connections Air Pump Output - Select an available output wire, typically a DPO (Digital Pulsed Output) that will be connected for the Air Pump.
    • Oil Metering Pump

      The Oil Metering Pump function allows for control of the stepper motor controlled oil injection system used on some Mazda Rotary engines. This provides a feedback signal to let the Elite ECU know the position of the valve, and a stepper motor output ...