Air Pump Wiring

Wiring

Connections

Air Pump Output - Select an available output wire, typically a DPO (Digital Pulsed Output) that will be connected for the Air Pump.

• Related Articles

• Air Pump

  This Function controls the Air Pump. Wiring Tab Connections Air Pump Output Active State Air Pump Tab Disable Air Pump on Decel Idle Delay Hysteresis Min RPM Max RPM Max Load Wiring Tab Connections Air Pump Output Select an available output wire, ...

• Fuel Pump (Wiring)

  The Orange/Blue wire is used to operate the fuel pump. When the Haltech ECU wants to operate the fuel pump it will close the fuel pump relay, which will supply the fuel pump with 12V from the Battery. It is important that the fuel pump is capable of ...

• Intake Air Bleed Wiring

  This node configures the output to be used for the Intake Air Bleed. A DPO (Digital Pulsed Input) is typically used, but any available output is acceptable. 

• Transient Throttle (Throttle Pump) Explained

  In this article we are unravelling one of the mysteries of tuning; the often talked about but rarely understood dark art of tuning the Throttle Pump, or as we call it here at Haltech the Transient Throttle Enrichment function. Transient Throttle If ...

• Ambient Air Temperature Sensor

  An Ambient Air Temperature Sensor measures the temperature of the air outside of the vehicle. Temperature sensors are typically two-wire sensors; a signal wire that is connected to an AVI, and a signal ground wire. On this node, the Ambient Air ...