RPM Limit

RPM Limit


When above or at this engine RPM, the Auxiliary RPM limiter will activate to reduce the engine speed, and the Cut Method and Type will be applied. This can be mapped in 2D

    • Related Articles

    • RPM Limiter

      The RPM Limiter is used to prevent engine damage by shutting down injection or ignition outputs at a set engine speed. Page Contents RPM Limiter Tab Cut Method Injection Ignition Cut Type Hard Cut Soft Cut Hysteresis Related Tables RPM Limiter End ...

    • Auxiliary RPM Limiter

      The Auxiliary (Aux) RPM Limiter function is used where a temporary lower RPM Limit is required. This is sometimes used for basic launch control or valet purposes. The Aux RPM Limiter requires an input to the Elite ECU to activate this function. Page ...

    • Target RPM

      Only available when Controller Mode is set to Closed Loop. This table sets the RPM that the Idle Control will try and achieve.

    • RPM Drop

      RPM Drop The RPM Drop node is only available if Gear Detection Type is set to RPM Drop in the Gear Detection function Gear Reset RPM The Engine RPM must fall below this amount to reset the gear position back to Gear 1. Gear RPM Drop Reset Time The ...

    • RPM Limiter Correction

      This table controls the fuel correction applied as the engine RPM approaches the Main RPM Limiter End RPM.  Generally, a small correction is made just before the engine reaches the RPM limiter to help soften the effects of the limiter.