Auxiliary CAN Bus Port

Auxiliary CAN Bus Port

The Auxiliary CAN Bus Port is designed to be used with a standard Deutsch DTM Series 4 pin connector. This port can be setup to broadcast Haltech CAN data or Vehicle Bus data. Pre-Terminated cables can be purchased to connect to the CAN Bus Port. Pinout is listed below.

Location

Description

Wire Colour

1

12V Supply

Red

2

Signal Ground

Black

3

CAN High

White

4

CAN Low

Blue

Looking at rear of Deutsch connector (Wire Side)

    • Related Articles

    • Auxiliary USB Port

      The Auxiliary USB Port (type A) is reserved for future expansion.

    • Haltech Can Bus Selection

      The Haltech CAN Bus is used to communicate with all Haltech CAN based expansion devices such as wideband controllers, display dashes and I/O expander boxes. Select the port where you would like the Bus to be broadcast.

    • Vehicle Can Bus Selection

      The Haltech Vehicle CAN is used to support vehicles which incorporate a vehicle CAN Bus. The Vehicle CAN Bus from the Haltech broadcasts messages required for the selected vehicle to interact with OEM modules and OEM Dashes. Select from the dropdown ...

    • Communications USB Port

      Connect the supplied USB cable (type B) to this port to program the ECU with the connected computer and supplied Elite Software Programmer, in real time.

    • Auxiliary RPM Limiter

      The Auxiliary (Aux) RPM Limiter function is used where a temporary lower RPM Limit is required. This is sometimes used for basic launch control or valet purposes. The Aux RPM Limiter requires an input to the Elite ECU to activate this function. Page ...