Base - Stage 2

Base - Stage 2

The Base - Stage 2 table exists only when the fuel Tuning Method is set to Injection Time and it serves as the raw injection time as delivered through the stage 2 injection system.
    • Related Articles

    • Fuel

      This section contains setup information for fuel configuration, including number of stages, injection mode, tuning method, and table selection. Page Contents Fuel Tuning Method Volumetric Efficiency Mass Air Flow Injection Time Auto V.E. Air Temp ...
    • Tuning Base Tables

      Tuning Method  Injection Time  The fuel table contain the base injection time for the given load and RPM at which the engine is operating. The base fuel map has the greatest influence on the air/fuel (A/F) mixtures.  With injection time tuning, you ...
    • Base Fuel Tuning

      The Base fuel table serves as the ECU's primary source for fuel delivery calculation. This table works in different ways depending on the Tuning Method set in the Fuel Tuning node. When Tuning Method is 'Volumetric Efficiency' this table is the VE of ...
    • Base Map Basics

      Today’s subject is Base Maps: what to expect and when to use one. Default Map When you go online with your Haltech ECU for the first time it will already have a preloaded Default Map. A Default Map has all the tuning maps, settings and functions ...
    • Flow

      This table sets the flow rate of the fuel injectors fitted to each injector output in the injection stage. If multiple injectors are fitted per injector output, this is the combined flow rate of all injectors per output. This data is usually supplied ...