Brake Lights

When enabled, this function will allow control of vehicle brake lights.

NOTE: Requires use of a brake pedal switch, set up through the "Sensors" navigation node.

Brake Light Pulsing (Requires Brake Pressure Sensor)

When enabled, this will pulse the brake light output under various conditions:

Hard Braking - When Brake Pedal State channel is ON (Hard Braking), and the vehicle speed is above 50 km/hr, the Brake Light Output will be pulsed at 5 Hz.

Emergency Stop - If Brake Pedal State channel remains ON, while vehicle speed drops below 14 km/hr, Hazard Lights will turn on (if enabled).

NOTE: After an emergency stop is initiated, the Hazard lights can be turned off by pressing the Hazard input. If Hazard input is a Push On/Push Off configuration, it will need to be pressed twice to disable the Hazard lights output.