Check Engine Light

Check Engine Light

Check Engine Light Page

Diagnostic Trouble Codes

Activation Criteria

Current DTCs only

Check Engine Light will show only illuminate when Diagnostic Trouble Codes are presented on the current engine run cycle

Current and past DTCs

Check Engine Light will illuminate when Diagnostic Trouble Codes are detected on the current engine run cycle and remain illuminated if DTCs are stored.

    • Related Articles

    • Check Engine Light Wiring

      Check Engine Light Wiring Page Options Light Output Enables or disables Check Engine Light function Output Mode Digital - Switched A check engine light can be configured to via an ECU DPO according to your needs.  CAN Output - Switched Using the CAN ...
    • Check Engine Light

      The Check Engine Light (CEL) function is used to display a light or warning to the driver that an error or fault condition exists in the Elite ECU. If the Knock Detection function is enabled it can also be configured to flash the CEL when the engine ...
    • Check Sensors

      Once you can go Online with the Elite Software Programmer, the next step is to check the various sensors connected. The easiest to check is the TPS. Move the throttle and check for movement of the TPS signal. Take the opportunity to calibrate your ...
    • How to use a timing light

      In this article we tackle one of the most requested topics – timing lights. It may be basic knowledge for many but it seems there’s still a lot of confusion surrounding the correct use of a timing light. What is it? A stroboscopic or timing light is ...
    • Don’t Blow Your Engine!

      We have all heard the stories and many of us have experienced first hand an engine failure. Whether it be a catastrophic “con rods hanging out of the block, piston melting, bearing crushing, block splitting” belter or just a simple gasket failure, ...