Corrections

Corrections



Various Fuel Correction tables can be enabled and disabled in your ECU from the Fuel Tuning - Corrections node. 

Each correction that is enabled will add the relevant tables to the Fuel Tuning > Corrections tree node. 
    • Related Articles

    • Fuel System

      Fuel System This page is used to configure the Fuel Injection System. Injection System Disable Injectors Enabling this will disable all injector outputs. (Default = Disabled) Enable Short Pulse Width Adder Enabling this will add a Short Pulse Width ...
    • Long Term Fuel Trim

      How it works The Long Term Fuel Trim is a function where the ECU can learn the correct amount of fuel required over a period of time so that the Target and Actual measured AFR are equal. Sometimes this is referred to as Auto-Tune. Both Narrowband and ...
    • How Flex Fuel Control Works

      In this article, we are taking a closer look at Flex Fuel Sensors. Topics covered are: what flex fuel sensors are, how they work, when you might need one and how to install and set one up on a Haltech ECU. It’s no secret ethanol based fuels are ...
    • Fuel

      This section contains setup information for fuel configuration, including number of stages, injection mode, tuning method, and table selection. Page Contents Fuel Tuning Method Volumetric Efficiency Mass Air Flow Injection Time Auto V.E. Air Temp ...
    • Lambda Corrections

      Various target lambda corrections can be enabled as a correction to the main Target Lambda table output. A Generic Correction and Fuel Composition Correction can be enabled from this node. Once enabled they will appear in the Lambda Corrections tree ...