Cut Pressure
Cut Pressure
Cut Pressure - If the boost pressure exceeds this amount for longer than the Delay time then the Overboost Cut will activate. Up to 2D mapping is available.
Related Articles
Overboost Cut
Enabling this function activates the Overboost Cut section in the ECU Navigator. The Cut Pressure table will then be available with up to 2D mapping. If the boost pressure exceeds the Cut Pressure setting for a length of time greater than the Delay, ...Overboost Cut
Overboost Cut Enabling this function activates the Overboost Cut section in the ECU Navigator. The Cut Pressure table will then be available with up to 2D mapping. If the boost pressure exceeds the Cut Pressure setting for a length of time greater ...Fuel Pressure Sensor, Diagnosis, and Engine Protection
This guide is based on the TI 150 psi pressure sensor. Other sensors can be used however please check wiring and calibration data to suit the sensor. About Haltech Part HT-010904 A fuel pressure sensor is a sensor that can read up to around 150 to ...Air Conditioner Pressure
An Air Conditioner Pressure Sensor allows the ECU to continuously monitor the pressure of the air conditioning system for safety purposes. An analog Air Conditioner Pressure Sensor is a powered sensor that typically has three wires; a 5V+ power wire, ...Power Steering Pressure Sensor
The Power Steering Pressure Sensor is used by the ECU to monitor pressure, and to perform tasks such as idle up when the pressure increases. The pressure sensor will also highlight any diagnostics in the Software if the pressure exceeds the indicated ...