Engine

Engine

This section will guide you through setting up the software and calibrating the necessary values to enable you to start your engine and achieve a steady idle. By the end of this section, the vehicle will not be ready to be driven, but will be ready to be tuned (which is described in the Tuning Guide).

This setup guide assumes basic knowledge of automotive fuel, ignition and triggering systems.

It is assumed that you are competent with operating your personal computer and are familiar with the basic concepts of the Windows operating system environment. This section will cover only the bare minimum information required to operate the ECU Manager software package for the setup procedure outlined. For more details on the advanced features, make sure that you read the relevant section for the features that you're interested in.

Note: Haltech will NOT provide support on operating your PC

Page Contents

Main

Basic engine information including engine type, firing order, and capacity.

Trigger

Trigger pattern and sensor configuration.

Fuel

Fuel configuration, including number of stages, injection mode, tuning method, and table selection.

Ignition

Ignition configuration, including coil arrangement selection, coil charge settings, and table selection.

    • Related Articles

    • Main

      This section is used for entering basic engine information including engine type, firing order, and capacity. Page Contents Engine Information Engine Capacity Engine Type Number of Cylinder/Rotors Max Cranking RPM Vehicle Information VIN Drive Type ...

    • Engine Setup Screen

      If a basemap for your engine is unavailable for your vehicle, then you will need to create your own settings by following through the settings below.

    • Engine Control Relay ( ECR )

      The engine control relay is the main relay that is used to enable and disable power to the engine management components. The Elite 2500 has one dedicated engine control relay output (DPO 6 (Black/Red)) capable of sinking 1A Max current ( ie 5 x 80 ...

    • Initial ECU Setup

      Your Elite Pro Plug-in Series ECU has been shipped in a default state. It will NOT start your vehicle without ESP configuration. Please follow the steps below to ensure you upload the correct map, set your vehicle variant and calibrate your ...

    • Setup

      Main Setup Settings for the ECU configuration can be found here. Table Setup Table axes setup for the currently selected table. Security Provides the tools for enabling or disabling the ECU Map security. To Index