Engine Setup Screen
If a basemap for your engine is unavailable for your vehicle, then you will need to create your own settings by following through the settings below.
Related Articles
Initial ECU Setup
Your Elite Pro Plug-in Series ECU has been shipped in a default state. It will NOT start your vehicle without ESP configuration. Please follow the steps below to ensure you upload the correct map, set your vehicle variant and calibrate your ...Engine
This section will guide you through setting up the software and calibrating the necessary values to enable you to start your engine and achieve a steady idle. By the end of this section, the vehicle will not be ready to be driven, but will be ready ...Setup
Main Setup Settings for the ECU configuration can be found here. Table Setup Table axes setup for the currently selected table. Security Provides the tools for enabling or disabling the ECU Map security. To IndexEngine Control Relay ( ECR )
The engine control relay is the main relay that is used to enable and disable power to the engine management components. The Elite 2500 has one dedicated engine control relay output (DPO 6 (Black/Red)) capable of sinking 1A Max current ( ie 5 x 80 ...Ignition
This section contains setup information for ignition configuration, including coil arrangement selection, coil charge settings, and table selection. Page Contents Ignition Angle Ignition Load Type MAP Sensor Air Mass/Cyl Throttle Position Sensor ...