Fuel Composition Scalar

Fuel Composition Scalar



This table directly controls the ratio of the Fuel Tuning Current Stoichiometry between Petrol and Ethanol and thus the fuel amount calculated to achieve the current target lambda. It is only active when the Fuel Type is set to Flex Fuel and the table should follow the output of the Fuel Composition sensor.

    • Related Articles

    • Flex Fuel Tuning Guide

      Although there are a number of ways to successfully tune an engine for flex fuel, this guide is intended to show a method that allows very accurate tuning over all ethanol blends together with Long Term Learning helping with the tuning process.  The ...
    • Fuel

      This section contains setup information for fuel configuration, including number of stages, injection mode, tuning method, and table selection. Page Contents Fuel Tuning Method Volumetric Efficiency Mass Air Flow Injection Time Auto V.E. Air Temp ...
    • Flex Fuel Composition/Temperature Sensor

      A Flex Fuel Composition/Temperature Sensor is digital sensor used to monitor the ethanol content of the fuel as well as the fuel temperature. This can be used with your Elite ECU for Flex Fuel tuning to suit a varying blend of ethanol in the fuel, ...
    • Fuel Composition Scalar

      Fuel Composition Scaler  This table is used to blend the Timing - Fuel Composition Correction Table. The number inputted represents the percentage of correction to be applied based on ethanol content of the fuel where a Fuel Composition Sensor is ...
    • Flex Fuel Composition/Temperature

      A Flex Fuel Composition Sensor is used to monitor the ethanol content as well as the temperature of the fuel. This can be used with your ECU for Flex Fuel tuning to suit a varying blend of ethanol in the fuel, for datalogging, and for Engine ...