Pre Crank Prime Pulse

When enabled from the Fuel Tuning node, the Pre Crank Prime Pulse table allows an initial pulse of fuel to be delivered to the engine at ECU power on.

This function is used to assist engine starting (especially when cold) to deliver additional fuel to help wet the runner walls.

To prevent excessive fuel from entering the engine, this function will only allow 3 consecutive pulses between engine starts.

• Related Articles

• Fuel Prime Pulse

  This table controls the volume of fuel injected into the engine when the ECU detects the engine has initially begun cranking and achieves synchronisation. It should deliver an amount of fuel as required to fire and start the engine whereby the ECU ...

• Pre-Control Duty Cycle

  Sequential Twin Turbo Pre-Control Duty Cycle Table This table sets the duty cycle sent to the secondary turbo pre-control valve. Up to 3D mapping is available.

• Crank Case Pressure Sensor

  The Crank Case Pressure Sensor is used to monitor the pressure of the engine oil in the Crankcase, a nd signal a warning if there are any large fluctuations, or if the pressure falls below the minimum or above the maximum indicated pressure. ...

• Fuel Tuning

  The Fuel Tuning node configures the main Fuel Tuning related information for the engine. Fuel Tuning Method Sets the method for fueling calculation. Most installations will use Volumetric Efficiency. See also Fuel Base. Auto V.E Air Temp Compensation ...

• Trigger Wiring (Crank and Cam Angle Sensors)

  The most critical sensor on the engine is the engine speed sensor, without this sensor the ECU would not know that the engine is moving and therefore it would never fire a spark nor inject any fuel. The ECU gets information from the crankshaft and ...