Generic Output Table
Generic Output Table
This table is only available if the Generic Output Mode is set to Table.
This table will appear with the name that has been configured, and allows up to 3D mapping (16x16) of your Generic Output, and can be configured to use any channel in your ECU for the axis. When the Signal Type is set to State, a “0” is used for the Off conditions, and a “1” is used for the On condition.
Related Articles
Min Output
This table sets the minimum amount of Idle Output that can be used. This will override any calculations or commanded Idle Output amounts.Generic Output
Generic Output The Generic Output function allows for a customised output to be configured in the ECU, where that output type is not directly listed in the system. Settings Name - Enter a name that is to be used for the Generic Output. This name will ...Generic Correction
Ignition Generic Correct Page - Unpopulated Generic Correction General purpose ignition timing correction table where custom axis can be configured by clicking on the GRID icon at the top of the screen, or by pressing the F3 key. Positive values will ...Generic Correction
The Target Lambda Generic Correction table is a user-configurable table that allows configuration to be tailored to your needs. By default, this correct table contains only one value which will create an offset of the entire Target Lambda table. This ...Recirc Valve Output Table
Recirculation Valve Output Duty Cycle Table The values in this table indicate the output duty of the recirculation valve which can be mapped over a range of channels. Up to 3D mapping is available.