Base Ignition Angle

Axis selection and changing values

This table is intended to be used with Ignition Load based on MAP or TPS set as the first/x (left to right) axis, and RPM as the second/y (bottom to top) axis. Changing the axis values can be accomplished by pressing F3 when the table is selected, then either editing an existing value or adding a new value. Note that if you edit an axis site value, the overall table values will be adjusted so that the shape of the table is unchanged.

Numbers entered within this table represent the number of degrees before top dead centre of ignition timing that is requested. A negative value represents a request for timing after top dead centre.

Base Ignition Angle

The Base Ignition Angle table serves as the ECU's primary reference for ignition timing before any corrections are applied.

• Related Articles

• Base Trailing Split Angle

  Axis selection and changing values This table is intended to be used with Ignition Load based on MAP or TPS set as the first/X (left to right) axis, and RPM as the second/Y (bottom to top) axis. Changing the axis values can be accomplished by ...

• Calibrating Ignition Timing

  Now is the time to triple-check your ignition settings in the software. If the settings are correct, turn off power to your ignition system and connect your ignition system to the ECU. It is a good idea to check your ignition coil temperatures ...

• How to use a timing light

  In this article we tackle one of the most requested topics – timing lights. It may be basic knowledge for many but it seems there’s still a lot of confusion surrounding the correct use of a timing light. What is it? A stroboscopic or timing light is ...

• Ignition Tuning

  Ignition Tuning Ignition Angle Lock Mode Allows the ignition advance to be fixed at a determined value to allow calibration of the TDC Offset. All ignition tables and corrections are ignored when this is active, and the ignition advance will not ...

• Cranking Ignition Angle

  Cranking Ignition Angle The amount of ignition advance to be used when the RPM is below the Max Cranking RPM value. Up to 3D mapping is available with this table. (Default = Enabled)