Ignition Gear Correction

Gear Correction

The amount of ignition timing correction for each gear. Positive values will advance timing by that amount, negative values will retard timing by that amount. This option is only available when a Gear Position Sensor or calculation has been enabled. Up to 4D mapping is available with this table. (Default = Disabled)

• Related Articles

• Gear Correction

  This table allows for a fuel correction based on the current Gear. This table is a 4D table and therefore each gear position has its own 3D table for correction.  Use the slider to select the appropriate 'slice' for the relevant gear correction ...

• Per Cylinder Correction

  Cylinder Correction Degree amount correction tables for each cylinder. This option is only available if the Trigger type supports full 720 degree engine synchronisation and Per Cylinder control. Enabling this option will give the user access to ...

• Ignition Tuning

  Ignition Tuning Ignition Angle Lock Mode Allows the ignition advance to be fixed at a determined value to allow calibration of the TDC Offset. All ignition tables and corrections are ignored when this is active, and the ignition advance will not ...

• Ignition Correction Attack Rate

  Attack Correction The Attack Rate table controls the rate in Degrees Per Engine Cycle at which the ignition timing can be advanced from a retarded value to a more advanced value. It is often used to smooth out the change in engine torque when there ...

• Ignition Decay Correction Rate

  Decay Correction The Decay Rate table controls the rate in Degrees Per Engine Cycle at which the ignition timing can be retarded from an advanced value to a more retarded value. This table is not often used compared to the Attack table, so default ...