Inputs Summary

Inputs Summary

  • Connect the Throttle Position Sensor (TPS).

  • Connect the Coolant Temperature Sensor.

  • Connect the Air Temperature Sensor.

  • Connect the MAP sensor (optional for normally aspirated).

  • Connect O2 sensor (optional).

  • Connect the crank angle sensor to Trigger (sometimes referred to as a crank trigger). Sometimes these are driven off the cam, but still give a crank position. Leave the wiring in such a way so that changes to sensor wiring can be made if required when setting up.

  • Connect any cam angle sensors if applicable to the Home input. Leave the wiring in such a way so that changes to sensor wiring can be made if required when setting up.


    • Related Articles

    • Outputs Summary

      When running the wiring for outputs, run any power and ground wiring back to the points where they will be connected, but do not connect power or ground connections yet. Run the injector wires within the loom to the fuel injectors (each injector ...

    • ABS Module - Installation Status for Transmission swaps

      This feature will allow automatic shifting of the ZF transmission without a factory ABS module present, such as when the ZF transmission has been used in a vehicle conversion. This feature may not fully replicate factory behaviour in every ...

    • REM Quick Start Guide

      The Race Expansion Module (REM) is used in conjunction with the Haltech Elite 2500 ECU to offer extra Input and Output functionally as well as advanced traction control and other advanced functions. Using the REM with the Elite 2500 allows sequential ...

    • Wastegate Valve Position Sensor

      A Wastegate Valve Position Sensor can be used to monitor wastegate behaviour. Page Contents Wiring Tab Connections Wastegate Valve Position Input(s) AVI Pull up SPI Sensor Type Pull up Calibration Tab Wiring Tab Connections Wastegate Valve Position ...

    • Fuel Return Flow Sensor

      The Fuel Return Flow sensor is used to monitor the flow of fuel returning from the fuel rail back to the fuel tank. Display warnings will flash in the ESP Software if the flow is to low or too high. Wiring Tab Connections Fuel Return Flow Input ...