End RPM
The value entered determines the maximum RPM allowed while the launch control input is in an active state.
An example of this is where a clutch pedal switch or transbrake is used to activate launch control. When triggered the engine will rev to a maximum of 5000rpm then resume normal operation after the launch control input is deactivated.
An example of this is where a clutch pedal switch or transbrake is used to activate launch control. When triggered the engine will rev to a maximum of 5000rpm then resume normal operation after the launch control input is deactivated.
Related Articles
End RPM
Main RPM Limiter End RPM The RPM on and above when all cylinders will be cut. This can be mapped in 3D (8x8).RPM Limiter Correction
This table controls the fuel correction applied as the engine RPM approaches the Main RPM Limiter End RPM. Generally, a small correction is made just before the engine reaches the RPM limiter to help soften the effects of the limiter.RPM Limiter
The RPM Limiter is used to prevent engine damage by shutting down injection or ignition outputs at a set engine speed. Page Contents RPM Limiter Tab Cut Method Injection Ignition Cut Type Hard Cut Soft Cut Hysteresis Related Tables RPM Limiter End ...Target RPM
Only available when Controller Mode is set to Closed Loop. This table sets the RPM that the Idle Control will try and achieve.Auxiliary RPM Limiter
The Auxiliary (Aux) RPM Limiter function is used where a temporary lower RPM Limit is required. This is sometimes used for basic launch control or valet purposes. The Aux RPM Limiter requires an input to the Elite ECU to activate this function. Page ...