Neutral Switch

Neutral Switch

The neutral switch prevents a vehicle from starting when in any gear position other than Park or Neutral . The switch can also monitor gear selection and reverse light feedback data.



Wiring Tab

Connections

Neutral Switch Input

Select an appropriate input to use for the Neutral Switch. An SPI or an AVI (Analogue Voltage Input) can be used.

Connection Type

SPI

An SPI (Synchronised Pulsed Input) requires configuring of the edge and the type of Sensor to be connected.

Edge Select

Falling is used when the input is grounded when the switch is activated. Rising is used when the input is supplied voltage when the switch is activated.

Sensor Type

Set to Hall Effect for all switch inputs

Pullup

Enables a pullup if required to generate a voltage when the switch is off.

AVI

An AVI will require Switch On and Switch Off voltages to be configured so the Elite ECU can know which voltages on the AVI meet the conditions required.

Switch On Voltage

The voltage either above or below where the switch is considered to be ON. When selecting an appropriate value some consideration should be given to allow for voltage fluctuations.

Switch Off Voltage

The voltage either above or below where the switch is considered to be OFF. When selecting an appropriate value some consideration should be given to allow for voltage fluctuations. Eg. if the switch is at 5V when it is Off and is grounded to 0V when the switch is On, you would set the On voltage to 1.0V and the Off Voltage to 4.0V.

Example 1

The switch is at 5V when it is Off and is grounded to 0V when the switch is On. Correct settings with tolerance would be to set the On voltage to 0.5V and the Off Voltage to 4.5V. i.e. when the voltage falls below 0.5V it is considered to be ON, and when it rises back above 4.5V it is considered to be OFF.

Example 2

The switch is at 2.5V when it is OFF, and is at 12V when it is ON. Correct settings with tolerance would be to set the On Voltage to 4.5V and the Off Voltage to 3.0V. i.e. when the voltage rises above 4.5V it is considered to be ON, and when it falls back below 3.0V it is considered to be OFF.

    • Related Articles

    • Neutral Switch

      The neutral switch prevents a vehicle from starting when in any gear position other than Park or Neutral. The switch can also monitor gear selection and reverse light feedback data. ​ Options Neutral Switch Input Mode - Select an appropriate input to ...

    • LPG Function

      LPG function is used when a vehicle has a LPG system fitted to the engine.Wiring a switch input for LPG select enables the ECU to disable the injectors and fuel pump when the LPG switch is active. Page Contents Wiring Tab Connections Switch Input ...

    • Torque Converter Control Function

      The Torque Converter Control function allows the electronic control of the torque converter lockup, as well as the ability to "dump" torque converter line pressure in order to control engine power in a drag racing application, as well as assisting ...

    • Oil Pressure Switch

      An Oil pressure switch is used as a safety device to indicate a loss in oil pressure. With the engine running, pressure is built up in the engine and the oil pressure warning will turn off. If the engine oil pressure drops too low, a warning will ...

    • Clutch Switch

      A Clutch Switch input can be used with your Elite ECU for Launch Control, for Gear Detection with a Gear Switch, and for datalogging and other tuning purposes. Page Contents Wiring Tab Connections Clutch Switch Input Connection Type SPI Edge Select ...