Related Articles
Trigger Activation Voltage
This table is used to set the voltage at which the ECU will accept the Trigger signal as valid and generate a trigger event. This table is only used when the Trigger Sensor type is set to Custom. When the sensor type is set to Reluctor, this table is ...
Shift Lights
Shift Lights Page Shift Light 1 through to Shift Light 3 are separate shift lights that can be used to indicate various shift points at different engine speeds. Shift Light 1 Activation RPM Enter the RPM above which you want the first shift light to ...
Shift Lights
Shift Light 1 through to Shift Light 3 are separate shift lights that can be used to indicate various shift points at different engine speeds. Page Contents Wiring Tab Options Number Of Shift Lights Connections Shift Light 1 Shift Light 2 Shift Light ...
Check Engine Light
Check Engine Light Page Diagnostic Trouble Codes Activation Criteria Current DTCs only Check Engine Light will show only illuminate when Diagnostic Trouble Codes are presented on the current engine run cycle Current and past DTCs Check Engine Light ...
Datalog Switch
Datalog Switch A Datalogging Switch input can be used with your ECU as the activation method to start and stop the internal memory datalogging. This node configures the input to be used for the datalogging switch. An SPI (Synchronised Pulsed Input) ...