Cylinder Ignition Correction
Cylinder Ignition Correction
This node allows the tuner to set individual cylinder ignition corrections. These corrections are applied when this nitrous stage is active. Numbers in the boxes are absolute corrections, so all ignition angles should be negative.
Related Articles
Per Cylinder Correction
Cylinder Correction Degree amount correction tables for each cylinder. This option is only available if the Trigger type supports full 720 degree engine synchronisation and Per Cylinder control. Enabling this option will give the user access to ...Per Cylinder Fuel Correction
The Cylinder correction tables allow a per-cylinder fuel correction to be made. This is commonly used to balance fuel delivery due to injector flow differences, intake manifold flow differences, or any contributing factor that would cause an ...Ignition Correction
This table sets an ignition correction that allows for ignition timing to be advanced or retarded when the RPM is above or below the Target RPM, and idle control is active. Typically the timing will be advanced when below the Target RPM to add engine ...RPM Limiter Ignition Correction
RPM Limiter Ignition Correction This table controls how many of degrees of ignition timing correction will be applied as the engine approaches the rev limiterCoolant Temp Ignition Correction
Coolant Temp Correction This table controls how many degrees of ignition timing correction will be applied for a given Coolant Temperature, and is often mapped against engine load as well. Positive values will advance timing by that amount, negative ...