Overall Ignition Correction

Overall Ignition Correction

Overall Ignition Correction



This table is only active if enabled in the Nitrous Controller node.

This table applies an ignition correction to all cylinders and is active whenever this nitrous stage is active. Numbers in this table are absolute corrections, so all ignition angles should be negative. Up to 3D mapping is available
    • Related Articles

    • Ignition Correction

      This table sets an ignition correction that allows for ignition timing to be advanced or retarded when the RPM is above or below the Target RPM, and idle control is active. Typically the timing will be advanced when below the Target RPM to add engine ...
    • RPM Limiter Ignition Correction

      RPM Limiter Ignition Correction This table controls how many of degrees of ignition timing correction will be applied as the engine approaches the rev limiter
    • Coolant Temp Ignition Correction

      Coolant Temp Correction This table controls how many degrees of ignition timing correction will be applied for a given Coolant Temperature, and is often mapped against engine load as well. Positive values will advance timing by that amount, negative ...
    • Coolant Temperature Ignition Correction

      Coolant Temp Correction This table controls how many degrees of ignition timing correction will be applied for a given Coolant Temperature, and is often mapped against engine load as well. Positive values will advance timing by that amount, negative ...
    • Ignition Gear Correction

      Gear Correction The amount of ignition timing correction for each gear. Positive values will advance timing by that amount, negative values will retard timing by that amount. This option is only available when a Gear Position Sensor or calculation ...