The maximum Drive-By-Wire throttle opening when the Pit Lane Speed Limiter is active.

By default this map is setup using the "Pit Lane Speed Limiter Before Cut" channel as the map axis. This channel represents how far the actual vehicle speed is away from the target pit lane speed. i.e. 0 in this table axis represents the actual vehicle speed being equal to the Pit Lane Speed Limiter speed, 20 in this axis the vehicle speed being 20 km/h below the Pit Lane Speed Limiter speed.

This function is used to reduce the amount of ignition or fuel cut required to limit Vehicle Speed, preventing excessive heat build-up and undesirable sounds (popping/banging) whilst the Pit Lane Speed Limiter function is active. This will also allow the driver to maintain 100% accelerator pedal (foot pedal to the floor) if desired.

NOTE: This function is only available when Drive-By-Wire is enabled within the ECU's Engine Functions settings.