Selector Position

Selector Position

Selector Position

The Selector Position node is only available if Selector Position Type is set to Voltage Input in the Gear Detection function


This node allows for the Selector Position Sensor calibration to be created. By pressing the Calibrate button with the gear selector in the listed position, the Nominal Voltage value will be filled out automatically with the currently read voltage. This automatically calibrates each Selector position.

Enable each gear position that is available on the selector by toggling on the Enable button.

Nominal Voltage

The voltage read by the selector position when the selector is in each position.

Voltage Tolerance

The voltage amount added either side of the nominal voltage for the current position. If the voltage of the selector falls within this distance from the nominal voltage, the selector is considered to be in the current position

    • Related Articles

    • Gear Position

      Gear Position The Gear Position node is only available if Gear Detection Type is set to Gear Position Sensor in the Gear Detection function This node allows for the Gear Position Sensor calibration to be created. By pressing the Calibrate button with ...
    • Gear Detection

      Wiring Options Gear Detection Type Select the method used to detect gear position. Gear Ratio - This method requires the Gear Ratios function to be enabled and configured. Gear Switch - This method is used with a gear change switch, such as a load ...
    • Transmission Control

      Transmission Control The Transmission Control function is able to control multiple styles of transmission. Some conventional automatic transmissions such as the Toyota A340e, pneumatically actuated sequential transmissions, as well as pneumatically ...
    • In Gear Base Duty

      In Gear Base Duty This sets the Base Duty Cycle of the Line Pressure when the Transmission Control function is holding the transmission in gear. If using Open Loop control: this is the duty cycle used. If using Closed Loop control: the PID control ...
    • Outputs for Gear

      Outputs For Gear This node allows the tuner to configure which transmission control outputs are on and off in which gear.  This information can be found for most gearbox's in the Workshop or Owners manual. If you have selected a preconfigured ...