Shift Point Load

Shift Point Load

Shift Point Load Table

The Shift Point Load table is only available if the Transmission Type in Transmission is set to Ford ZF 6-speed.

Axis selection and changing values

The horizontal axis (left to right) is fixed to Engine Demand to make sure the Transmission shifts under the correct circumstances. Changing the axis values can be accomplished by pressing F3 when the table is selected, then either editing an existing value or adding a new value. Note that if you edit an axis site value, the overall table values will be adjusted so that the shape of the table is unchanged.
Engine Demand is a non-linear indicator of how much torque is being requested from the engine. It is closely related to throttle and pedal positions.

Tuning

The purpose of this table is for tuning shift points. The output value of this table (shift point load %)  is used as the load axis for the shift point calculations within the Transmission Control Module. Automatic shifting during cruise control is heavily influenced by the tuning of this table.
As a general rule, increasing the values in the table will cause the shift point to occur at a higher RPM. This can make the car feel sportier, but may be worse for fuel economy. It is recommended that the table begins with 0% and ends with 100%. 
    • Related Articles

    • RPM Shift Point

      RPM Shift Point Table This table is only available if RPM Shift Point Enable is on in the Transmission Control function. Like the Auto Mode Shift Points Table, this is a special table which behaves differently to normal tables. The left axis is fixed ...
    • ZF 6 Speed Support

      How it Works The ZF 6HP26 6 Speed Automatic Transmission is supported by the Haltech Elite Pro Plug-in Ford Falcon I6 ECU through communication with the factory Transmission Control Module (TCM). The Adaptive Automatic Mode (Drive), Performance ...
    • Auto Mode Shift Points

      Auto Mode Shift Point Table This is not available if Auto Shift Option is set to Auto Disabled. This is a special table which behaves differently to normal tables and uses special values in the left axis of the table. The left axis of the table is ...
    • Shift Inhibit

      Shift Inhibit Table The Shift Inhibit table allows the tuner to prevent gear shifts which are either unwanted and/or dangerous. track.  Shift Inhibit will only block shifts if the functionality is enabled and the specific shift is listed on the left ...
    • Flat Shift Link Delay

      Flat Shift Link Delay Table This table is only available if Flat Shift Link Option is enabled in the Transmission Control function. How much time between the Flat Shift Torque Reduction and/or Throttle Blip and the Transmission Control outputs ...