Staging Indicator

This function uses an output to indicate when the engine is in the staging section of map, i.e When the load has increased beyond the Staging Load Bar in the Fuel Setup page.There are no parameters to setup for this output. This output will not activate if staged fuel is not enabled. 

Note: The staging signal does not pulse with the other injectors. It switches on and stays activated while the load is above the staging point. The pulsed outputs can be configured using the Extra Injector output type. 

 

• Related Articles

• Staging Indicator

  This function uses an output to indicate when the engine is in the staging section of map, i.e When the load has increased beyond the Staging Load Bar in the Fuel Setup page.There are no parameters to setup for this output. This output will not ...

• Indicator Wiring

  Wiring Left Indicator Input       This node allows you to assign the input for the left indicator input.             Edit - Click to assign/reassign an available input as Left Indicator Input.             Clear - Click to reset Input assignment. ...

• Injection Staging

  This node contains settings and tables for the injection stage. There is a separate node for each stage of injection. Setup - this sets the injector current control mode for each injector output on this stage. This setting must be set correctly for ...

• Stage Indicator Wiring

  Options Second Stage Indicator Enables the second stage indicator light. Third Stage Indicator Enables the third stage indicator light. Fourth Stage Indicator Enables the fourth stage indicator light. Connections Select an available output wire, ...

• Indicators

  Indicators When enabled, this function allows users to set up an indicator (turn signal) light output. Output Mode       Constant: This will provide a constant output, relying on an external system to pulse power to the light.        Pulsing: This ...