Stall Saver

Stall Saver

Stall Saver

The Stall Saver function effectively prevents the engine from stalling by increasing the RPM if it falls below the RPM indicated in the function settings. 
This function is also now incorporated in Idle Control.



On Value - When the engine RPM is at this value, the Stall Saver function will activate. This is not a common function since idle control systems have been installed but is typically wired to a solenoid valve or throttle kicker to supply more air when the engine is about to stall.

Wiring

This node allows for the selection of an output to a solenoid valve or throttle kicker.
Typically a DPO (Digital Pulsed Output) will be connected for the Stall Saver function.

    • Related Articles

    • Stall Saver

      The Stall Saver function effectively prevents the engine from stalling by increasing the RPM if it falls below the RPM indicated in the function settings. This function is also now incorporated in the idle control function. Wiring Tab Connections ...

    • Starter Motor

      Starter Motor GeneralMax Starting Attempt Time - The maximum amount of time (in seconds) that the starter will be turned On per start attempt. This setting is ignored if there is no Start button / key input to the ECU. Minimum = 0.5, Maximum = 10.0. ...

    • Traction Control User's Guide

      Introduction This is a guide on how to use the Traction Control Function for typical street or mild racing use.  This guide will focus on the newer Percentage Cut system found on Nexus VCU and Elite ECU with firmware v2.34-onwards.  The Percentage ...

    • Sensing The Speed – How Wheel Speed Sensors Work

      A vehicle speed sensor’s job is relatively simple. It measures the speed of a rotating shaft and sends that information to the engine management system for processing. The two most important things to know about wheel speed sensors are: 1. What kind ...

    • Sensing The Speed – How Wheel Speed Sensors Work

      A vehicle speed sensor’s job is relatively simple. It measures the speed of a rotating shaft and sends that information to the engine management system for processing. The two most important things to know about wheel speed sensors are: 1. What kind ...