Cut Percentage

Cut Percentage



When the Cut Percentage Traction Control method is selected this table controls the rate of ignition or fuel cut events based on the Traction Control Slip Error. Higher wheel slip error results in increased power reduction.


Traction Control Slip Error is the difference in measured wheel slip and the output of the desired slip table. Positive Slip Error numbers mean the measured slip is greater than desired.


    • Related Articles

    • Cut Percentage

      Flat Shift Cut Percentage Table Available when the Flat Shift Mode includes fuel and/or ignition cuts. This allows for up to 3D (8x8) mapping of the percentage cut to be applied during a flat shift in order to reduce torque.

    • Cut Percentage

      Available only when the Cut Type is set to Cut Off. Allows the user to apply a user definable percentage cut to the engine, over a range of conditions. This can be mapped in 3D (8x8).

    • Driveshaft RPM Percentage Cut

      Help text for this item is coming soon.

    • Engine RPM Percentage Cut

      Help text for this item is coming soon.

    • Cut Pressure

      Cut Pressure Cut Pressure - If the boost pressure exceeds this amount for longer than the Delay time then the Overboost Cut will activate. Up to 2D mapping is available.