Driveshaft RPM Percentage Cut

• Related Articles

• RPM Limiter

  The RPM Limiter is used to prevent engine damage by shutting down injection or ignition outputs at a set engine speed. Page Contents RPM Limiter Tab Cut Method Injection Ignition Cut Type Hard Cut Soft Cut Hysteresis Related Tables RPM Limiter End ...

• Cut Percentage

  Available only when the Cut Type is set to Cut Off. Allows the user to apply a user definable percentage cut to the engine, over a range of conditions. This can be mapped in 3D (8x8).

• Cut Percentage

  Flat Shift Cut Percentage Table Available when the Flat Shift Mode includes fuel and/or ignition cuts. This allows for up to 3D (8x8) mapping of the percentage cut to be applied during a flat shift in order to reduce torque.

• Cut Percentage

  When the Cut Percentage Traction Control method is selected this table controls the rate of ignition or fuel cut events based on the Traction Control Slip Error. Higher wheel slip error results in increased power reduction. Traction Control Slip ...

• Driveshaft RPM Sensor

  The Driveshaft RPM sensor is used to measure driveshaft RPM. This information can be used to adjust engine parameters including, but not limited to: Fueling, Ignition timing and boost control. The Driveshaft RPM is also critical in the use of the ...