Engine RPM Percentage Cut

• Related Articles

• Cut Percentage

  Available only when the Cut Type is set to Cut Off. Allows the user to apply a user definable percentage cut to the engine, over a range of conditions. This can be mapped in 3D (8x8).

• RPM Drop

  RPM Drop The RPM Drop node is only available if Gear Detection Type is set to RPM Drop in the Gear Detection function Gear Reset RPM The Engine RPM must fall below this amount to reset the gear position back to Gear 1. Gear RPM Drop Reset Time The ...

• RPM Limiter Correction

  This table controls the fuel correction applied as the engine RPM approaches the Main RPM Limiter End RPM.  Generally, a small correction is made just before the engine reaches the RPM limiter to help soften the effects of the limiter. 

• RPM Limiter Ignition Correction

  RPM Limiter Ignition Correction This table controls how many of degrees of ignition timing correction will be applied as the engine approaches the rev limiter

• RPM Limiter

  The RPM Limiter is used to prevent engine damage by shutting down injection or ignition outputs at a set engine speed. Page Contents RPM Limiter Tab Cut Method Injection Ignition Cut Type Hard Cut Soft Cut Hysteresis Related Tables RPM Limiter End ...