Related Articles
Target RPM
Only available when Controller Mode is set to Closed Loop. This table sets the RPM that the Idle Control will try and achieve.
Target Lambda
The Target Lambda table serves as a major part of the fuel delivery calculation in your Nexus ECU. It maps out the resultant mixture you want the engine to run at under various load and RPM points and is used in both open loop and closed loop ...
Shifting Target
Shifting Target Table This sets the target Line Pressure when the Transmission Control function is shifting between gears. If there is a base map available for your transmission, it is recommended to import the Target Pressure tables from there. If ...
Post Start Target Offset
This table sets an amount of RPM that is added to the Target RPM upon engine startup. It is used to help an engine become stable after initial starting and is timed to eventually give no extra RPM. Up to 3D mapping is available.
RPM Drop
RPM Drop The RPM Drop node is only available if Gear Detection Type is set to RPM Drop in the Gear Detection function Gear Reset RPM The Engine RPM must fall below this amount to reset the gear position back to Gear 1. Gear RPM Drop Reset Time The ...