Tools and Materials that you may need

Tools and Materials that you may need

Installation of this system can be easily carried out by professional mechanic(s) and most experienced home mechanics if some basic tools and components are available:

  • Voltmeter or Test Light

  • A selection of screwdrivers and spanners

  • Soldering Iron and solder

  • Wire Cutters and Pliers

  • Crimping Tool and assorted terminals

  • Personal Computer (preferably a laptop or portable computer) running Windows XP or above with a USB port.

  • A good quality Timing Light

    • Related Articles

    • Tools

      Firmware Version The firmware version in the ECU can be checked here. Upgrade Firmware The ECU's firmware can be upgraded from this menu. Reboot ECU The ECU can be rebooted from this menu. Note: On PRO Harness System ECU's, please do not perform this ...

    • Before You Begin

      PLEASE READ THIS ENTIRE MANUAL BEFORE STARTING. At the very least, you should read the wiring and installation section of the manual before you begin wiring. The greater your knowledge of the operation of the Haltech system, the easier you will find ...

    • Devices

      You will find the Device tab in the Main Setup Menu (found by pressing F4 or by clicking the Setup). This tab allows you to turn on and assign CAN inputs or outputs to either the Aux CAN Bus Port or to the Main connectors on the Elite ECU. Page ...

    • Setup

      Main Setup Settings for the ECU configuration can be found here. Table Setup Table axes setup for the currently selected table. Security Provides the tools for enabling or disabling the ECU Map security. To Index

    • Datalog

      Your Elite Series ECU has the capability to datalog to its internal memory. Datalogging can be enabled conditionally off a channel parameter, a switch, or enabled to log all the time. You can also log via the ESP software to your laptop. Onboard ...