Shift

Torque Reduction Shift Tables

This table is used to determine the amount of ignition retard applied between each gear shift in order to reduce the torque. There is one table available to each gear shift (for example, shifting from first gear to second gear, from second gear to third gear, and so on). Up to 3D mapping is available.

• Related Articles

• Shift Inhibit

  Shift Inhibit Table The Shift Inhibit table allows the tuner to prevent gear shifts which are either unwanted and/or dangerous. track.  Shift Inhibit will only block shifts if the functionality is enabled and the specific shift is listed on the left ...

• Shift Duration

  Shift Duration Table The Shift Duration table determines how long the outputs are on for during a shift. Most applications with regulated air pressure will use a single cell in the table. An application without regulated pressure supply might require ...

• RPM Shift Point

  RPM Shift Point Table This table is only available if RPM Shift Point Enable is on in the Transmission Control function. Like the Auto Mode Shift Points Table, this is a special table which behaves differently to normal tables. The left axis is fixed ...

• Flat Shift

  Flat Shift The Flat Shift function allows for full throttle gear changes to occur without throttle lifting. There are a number of types of Flat Shift but this is commonly used for sequential gearboxes with an input from a load cell. The engine power ...

• Auto Mode Shift Points

  Auto Mode Shift Point Table This is not available if Auto Shift Option is set to Auto Disabled. This is a special table which behaves differently to normal tables and uses special values in the left axis of the table. The left axis of the table is ...