Wi-Fi

Wi-Fi

Wi-Fi




Wi-Fi Setup


NOTE: The NEXUS ECU must be powered in order to set up the Wi-Fi communications. This may be through USB power or Vehicle power.

SSID - Set an SSID for the ECU. Your SSID must be at least one character.
Password - Set a unique password for your ECU. Your password must be at least 8 characters. 

Click Apply to save the SSID and Password to the ECU.

The Wi-Fi Status can be seen above the Apply button at all times.

    • Related Articles

    • Connections

      Connections This page is used to enable and disable any Connections such as CAN and Wi-Fi. The Wi-Fi name can be clicked on to navigate to the Wi-Fi tree node. Any errors will be highlighted in red for your attention. 

    • Nexus R3 VCU Pinout

    • Nexus Rebel LS

      Overview The Rebel LS ECU is one of Haltech’s advanced engine control units in the Nexus range, offering additional functionality beyond simply controlling your GM Gen III or Gen IV LS engine. It functions not only as an engine control unit but also ...

    • Firing Angle BTDC

      This table sets the firing angle of the injection events for this stage of injection expressed as degrees before TDC compression. If 'Injector Timing Method' is set to 'End of Injection', then this table sets the angle at which the injection events ...

    • Shift to First

      Shift to First    This node is only available if Shift to First Enable is on in the Transmission Control function. A car where the ECU only controls up-shifts in a sequential transmission will often use this in drag race scenarios. It should be ...