B=Black
BR=Brown
G=Green
GY=Grey
L=Blue
O=Orange
P=Pink
R=Red
V=Violet
Y=Yellow
W=White
(SHD) = Shielded Cable
When two Colours are used in a wire by the alphabetical code, the first letter indicates the basic wire colour, the second colour indicates the colour of the stripe.
Related Articles
Drive By Wire Throttle Wiring
Drive by wire technology is supported by the Elite 2500 ECU's and requires wiring of an Electronic Throttle and Accelerator Pedal Position sensor. Wiring setup and connection allocation can be found within the function in the setup page. This wiring ...
Power and Ground Wiring
Black (Battery Ground) Red_Green / Red / Red_White (Battery Supply 12V) Pink (Ignition Switch 12V) Locate and connect the following flying leads.(Wiring based on the Haltech Elite Premium Harnesses)
Drive By Wire
The Drive By Wire (DBW) function allows your Elite ECU to accept an input from an Accelerator Pedal Position (APP) sensor and use this to control the output to a DBW Throttle Body. This type of control allows mapping of the throttle body opening ...
Fuel Pump (Wiring)
The Orange/Blue wire is used to operate the fuel pump. When the Haltech ECU wants to operate the fuel pump it will close the fuel pump relay, which will supply the fuel pump with 12V from the Battery. It is important that the fuel pump is capable of ...
Nitrous Relay Wiring (Multistage)