Brake Lights Wiring

Wiring

Brake Light Output

      This node allows you to assign the output for Brake Light Output.

            Edit - Click to assign/reassign an available output as Brake Light Output.

            Clear - Click to reset Output assignment.

• Related Articles

• Brake Pressure Front / Rear

  Brake Pressure Front / Rear Sensor A Brake Pressure Sensor can be used with your ECU for datalogging and for electrical control. A Brake Pressure Sensor is a powered sensor that typically has three wires; a 5V+ power wire, a signal wire to the ECU, ...

• Brake Lights

  Brake Lights When enabled, this function will allow control of vehicle brake lights.       NOTE: Requires use of a brake pedal switch, set up through the "Sensors" navigation node.       Brake Light Pulsing (Requires Brake Pressure Sensor)       ...

• Reverse Lights Wiring

  Wiring Reverse Light Output       This node allows you to assign the output for reverse lights.             Edit - Click to assign/reassign an available output as Reverse Light Output.             Clear - Click to reset Output assignment.

• Brake Pedal Switch

  Brake Pedal Switch A Brake Pedal Switch can be used with your ECU for additional Drive-By-Wire safety, datalogging, Cruise Control, Starter Motor Lockout and many other uses and conditions. Up to 2 brake pedal switches can be enabled and configured. ...

• Headlights Wiring

  Wiring Headlight Input       This node allows you to assign the input for the headlamps.             Edit - Click to assign/reassign an available input as Headlight Input.             Clear - Click to reset Input assignment. High Beam Input       ...