Trigger System
Trigger Glitch Filter
This table sets the amount of time in microseconds that the signal pulse must remain in a transitioned state in order for the signal to be accepted as valid. Any pulse shorter than this time will be considered a glitch on the signal and rejected by ...
Trigger Activation Voltage
This table is used to set the voltage at which the ECU will accept the Trigger signal as valid and generate a trigger event. This table is only used when the Trigger Sensor type is set to Custom. When the sensor type is set to Reluctor, this table is ...
Trigger Arming Threshold Voltage
This table is used to set the voltage threshold at which the ECU will start listening for the activation edge on the trigger signal. It is only active when the Trigger Sensor Type is set to Reluctor or Custom. The values in this table are used in ...
TDC Offset Angle Table
The TDC Offset Angle Table allows for fine adjustment where the locked ignition timing advances or retards over RPM, and allows the ignition timing to match between ECU and Crank at all RPM. This may be required due to sensor delays. The table output ...
Trigger System
Engine Configuration - Trigger System Page This section contains setup information for configuring your engines' trigger system, including crank and cam trigger patterns and sensors. Select Trigger System This button allows automatic selection of ...