Stage
Flow Percentage
This table controls the percentage of total fuel delivery that this stage of injection will deliver to the engine. This table is only available for Injection Stage 2 and above, and when 'Nexus Style' staging is used. NOTE: Incorrect tuning of the ...
Short Pulse Width Adder
The Short Pulse Width Adder table is used to adjust the opening time of the injector in its non-linear operating zone. Although injectors deliver fuel amounts linear to their on-time across most of their operating range, there is a portion of this on ...
Flow
This table sets the flow rate of the fuel injectors fitted to each injector output in the injection stage. If multiple injectors are fitted per injector output, this is the combined flow rate of all injectors per output. This data is usually supplied ...
Dead Time
(example only) Fuel Injector Dead Time is the mechanical delay from when the injector solenoid coil is energised to when the injector stars flowing fuel. It is also known as 'injector lag time' or 'injector latency'. Dead Time is unique for every ...
Firing Angle BTDC
This table sets the firing angle of the injection events for this stage of injection expressed as degrees before TDC compression. If 'Injector Timing Method' is set to 'End of Injection', then this table sets the angle at which the injection events ...
Injection Staging
This node contains settings and tables for the injection stage. There is a separate node for each stage of injection. Setup - this sets the injector current control mode for each injector output on this stage. This setting must be set correctly for ...