Transmission Control
Transmission Control Wiring
Wiring Options Number of Outputs - This setting is only required for some Transmission Types. It is greyed out when the ECU can determine the number of outputs from the Transmission Type and/or the Number of Gears (e.g. GM 4L60 uses 2 gear select ...
Outputs for Gear
Outputs For Gear This node allows the tuner to configure which transmission control outputs are on and off in which gear. This information can be found for most gearbox's in the Workshop or Owners manual. If you have selected a preconfigured ...
Spool Up Gear
Spool Up Gear This node is only available if Spool Up Gear Enable is on in the Transmission Control function. This example configuration will obviously require at least one Brake Pedal Switch and/or Brake Pressure Sensor, the Vehicle Speed function, ...
Shift to First
Shift to First This node is only available if Shift to First Enable is on in the Transmission Control function. A car where the ECU only controls up-shifts in a sequential transmission will often use this in drag race scenarios. It should be ...
Flat Shift Link Delay
Flat Shift Link Delay Table This table is only available if Flat Shift Link Option is enabled in the Transmission Control function. How much time between the Flat Shift Torque Reduction and/or Throttle Blip and the Transmission Control outputs ...
Shift Point Load
Shift Point Load Table The Shift Point Load table is only available if the Transmission Type in Transmission is set to Ford ZF 6-speed. Axis selection and changing values The horizontal axis (left to right) is fixed to Engine Demand to make sure the ...
3-2 Control Duty Cycle
3-2 Control Duty Cycle Table This table is only available if the Transmission Type in Transmission is set to GM 4L60E. This table controls the duty cycly of a solenoid that is unique to the 4L60e, and is only utilised to smooth the downshift from 3rd ...
Shift Duration
Shift Duration Table The Shift Duration table determines how long the outputs are on for during a shift. Most applications with regulated air pressure will use a single cell in the table. An application without regulated pressure supply might require ...
Shift Inhibit
Shift Inhibit Table The Shift Inhibit table allows the tuner to prevent gear shifts which are either unwanted and/or dangerous. track. Shift Inhibit will only block shifts if the functionality is enabled and the specific shift is listed on the left ...
RPM Shift Point
RPM Shift Point Table This table is only available if RPM Shift Point Enable is on in the Transmission Control function. Like the Auto Mode Shift Points Table, this is a special table which behaves differently to normal tables. The left axis is fixed ...
Auto Mode Shift Points
Auto Mode Shift Point Table This is not available if Auto Shift Option is set to Auto Disabled. This is a special table which behaves differently to normal tables and uses special values in the left axis of the table. The left axis of the table is ...
Transmission Control
Transmission Control The Transmission Control function is able to control multiple styles of transmission. Some conventional automatic transmissions such as the Toyota A340e, pneumatically actuated sequential transmissions, as well as pneumatically ...