Aux Limiter
Aux Limiter Wiring
Connctions AUX RPM Limiter Switch Input Select an appropriate input to use for the Aux RPM Limiter Switch. An SPI or an AVI (Analogue Voltage Input) can be used. Connection Type SPI An SPI (Synchronised Pulsed Input) requires configuring of the edge ...
Adder
Available only when the Cut Type is set to Cut Off. The Adder value changes the pattern in which cylinders are cut. Recommended values for the Adder value setting which will ensure the most even pattern and the smoothest cut are shown below. ...
Cut Percentage
Available only when the Cut Type is set to Cut Off. Allows the user to apply a user definable percentage cut to the engine, over a range of conditions. This can be mapped in 3D (8x8).
RPM Limit
When above or at this engine RPM, the Auxiliary RPM limiter will activate to reduce the engine speed, and the Cut Method and Type will be applied. This can be mapped in 2D
Aux Limiter
The Auxiliary (Aux) RPM Limiter function is used where a temporary lower RPM Limit is required. This is sometimes used for basic launch control or valet purposes. The Aux RPM Limiter requires an input to the Elite ECU to activate this function. Aux ...