Ignition Zero Demand

Ignition Zero Demand


Zero Demand Ignition Angle

This table is only active when the Throttle Position for a cable throttle or the Accelerator Pedal Position for a DBW throttle is below the Throttle Limits i.e closed throttle – User Demand Minimum value. Up to 2D mapping is available with this table.


    • Related Articles

    • Zero Demand

      This table is only active when the Throttle Position for a cable throttle or the Accelerator Pedal Position for a DBW throttle is below the Throttle Limits – User Demand Minimum value. Up to 2D mapping is available with this table. When VE or Mass ...

    • Transient Throttle

      What is Transient Throttle ? Transient Throttle is a fuel correction function used to compensate for an opening or closing throttle body. As the throttle is opened and air enters the inlet manifold there is a period of time where the manifold ...

    • Ignition Tuning

      Ignition Tuning Ignition Angle Lock Mode Allows the ignition advance to be fixed at a determined value to allow calibration of the TDC Offset. All ignition tables and corrections are ignored when this is active, and the ignition advance will not ...

    • Throttle Follower

      Throttle Follower Target Axis selection and changing values This table is intended to be used with RPM set as the first/x (left to right) axis and Pedal Position Source as the second/y (bottom to top) axis, though these axes are user configurable to ...

    • Ignition

      This section contains setup information for ignition configuration, including coil arrangement selection, coil charge settings, and table selection. Page Contents Ignition Angle Ignition Load Type MAP Sensor Air Mass/Cyl Throttle Position Sensor ...