Dual Fuel Tank Transfer
The Dual Fuel Tank Transfer function enables the transfer of fuel from a secondary fuel tank into a primary fuel tank for dual tank equipped vehicles. Outputs available include the transfer pump, control solenoid and transfer light. Inputs available include the main tank level, secondary tank level and a transfer request switch.
|
Page Contents |
Wiring Tab
Options
Transfer Request Mode
Transfer while active
When selected, will transfer fuel while the button is pressed
Press to Start/Stop Transfer
When selected, transfer will begin after one press of button, and will stop once button is pressed again.
Main Tank Full Source
The method by which the main tank fuel level is detected
None
When selected, will disable the main tank full source input
Switch Input
Select when a fuel level switch is used to determine if the main fuel tank is full
Fuel Level Sensor
Use when a fuel level sensor is installed and configured in ESP to determine when the main fuel tank is full
Secondary Tank Empty Source
The method by which the secondary tank fuel level is detected
None
When selected, will disable the secondary fuel tank empty input
Switch Input
Select when a switched input is used to determine if the secondary fuel tank is empty
Transfer Status Light Enable
Enables a transfer status light, which will illuminate when fuel transfer is occurring
Transfer Control Solenoid Enable
Enables a transfer control solenoid for dual fuel transfer vehicles equipped with a transfer solenoid
Fuel Transfer Settings Tab
Main Tank Stop Level
Available when main tank full source is set to Fuel Level Sensor. This is the main fuel tank level that the transfer will stop at.
Max Transfer Time Enable
Allows a condition for the amount of time a transfer can occur for before disabling
Max Transfer Time
The maximum amount of time a fuel transfer will occur for before disabling
Max Vehicle Speed Enable
Available when a Vehicle Speed Sensor is enabled. Allows a condition for the maximum vehicle speed the vehicle can travel without disabling an active transfer
Max Vehicle Speed
Once the vehicle is travelling above this set speed, the fuel transfer will disable and stop.
Related Articles
Dual Fuel Tank Transfer
The Dual Fuel Tank Transfer function enables the transfer of fuel from a secondary fuel tank into a primary fuel tank for dual tank equipped vehicles. Outputs available include the transfer pump, control solenoid and transfer light. Inputs available ...Fuel Tank Pressure Sensor
A Fuel Tank Pressure Sensor is used to determine the pressure in the fuel tank of a vehicle. This sensor also monitors the vapors in the engine. The information gathered is sent to the Haltech ECU and if there is an issue, then the check engine light ...LPG Function
LPG function is used when a vehicle has a LPG system fitted to the engine.Wiring a switch input for LPG select enables the ECU to disable the injectors and fuel pump when the LPG switch is active. Page Contents Wiring Tab Connections Switch Input ...Torque Converter Control Function
The Torque Converter Control function allows the electronic control of the torque converter lockup, as well as the ability to "dump" torque converter line pressure in order to control engine power in a drag racing application, as well as assisting ...Fuel Tank Pressure Sensor
A Fuel Tank Pressure Sensor is used to determine the pressure in the fuel tank of a vehicle. The fuel tank pressure sensor is used to detect leaks as part of the EVAP, or Evaporative Emissions, system. On this node, the Fuel Tank Pressure sensor ...