TDC Offset Angle Table

TDC Offset Angle Table

The TDC Offset Angle Table allows for fine adjustment where the locked ignition timing advances or retards over RPM, and allows the ignition timing to match between ECU and Crank at all RPM. This may be required due to sensor delays.

The table output value is added or subtracted from the TDC Angle. 

    • Related Articles

    • Tech Tip: How to set your TDC Offset Angle

      Synchronizing your trigger system with your ECU is a vital stop in the tuning process. In this video we explain the important yet often misunderstood subject of TDC Offset Angle, also known as Trigger Angle. We break down the process and explain it ...

    • Calibrating Ignition Timing

      Now is the time to triple-check your ignition settings in the software. If the settings are correct, turn off power to your ignition system and connect your ignition system to the ECU. It is a good idea to check your ignition coil temperatures ...

    • Trigger System

      Engine Configuration - Trigger System Page This section contains setup information for configuring your engines' trigger system, including crank and cam trigger patterns and sensors. Select Trigger System This button allows automatic selection of ...

    • Firing Angle BTDC

      This table sets the firing angle of the injection events for this stage of injection expressed as degrees before TDC compression. If 'Injector Timing Method' is set to 'End of Injection', then this table sets the angle at which the injection events ...

    • Base Trailing Split Angle

      Axis selection and changing values This table is intended to be used with Ignition Load based on MAP or TPS set as the first/X (left to right) axis, and RPM as the second/Y (bottom to top) axis. Changing the axis values can be accomplished by ...