Torque Reduction
Torque Reduction Wiring
Wiring This node allows an output to be configured as the torque reduction output. Typically a DPO (Digital Pulsed Output) would be used for the Torque Reduction Output
Shift
Torque Reduction Shift Tables This table is used to determine the amount of ignition retard applied between each gear shift in order to reduce the torque. There is one table available to each gear shift (for example, shifting from first gear to ...
Ignition Offset
Torque Reduction Ignition Offset Table This table allows for an ignition timing percentage correction to be applied to the shift table. This can assist when more or less ignition retard is required under certain conditions (for example if the air ...
Cut Time
Torque Reduction Cut Time Table This table is used to define the amount of time that a torque reduction event will occur for. This begins after the Delay Time has lapsed.
Delay Time
Torque Reduction Delay Time Table This table is used to define the amount of time between the detection of a shift via the gear position sensor/switch, and the application of a torque reduction. Up to 2D mapping is available.
Torque Reduction
Torque Reduction The Torque Reduction Function is used for drag racing bikes, to allow for the control of the engines acceleration during upshift gear changes. This control is achieved through the application of fuel and/or ignition pulse cuts, and ...