Status and Power LEDs, CAN, and USB ports
Vehicle Can Bus Selection
The Haltech Vehicle CAN is used to support vehicles which incorporate a vehicle CAN Bus. The Vehicle CAN Bus from the Haltech broadcasts messages required for the selected vehicle to interact with OEM modules and OEM Dashes. Select from the dropdown ...
Haltech Can Bus Selection
The Haltech CAN Bus is used to communicate with all Haltech CAN based expansion devices such as wideband controllers, display dashes and I/O expander boxes. Select the port where you would like the Bus to be broadcast.
CAN Bus Overview
The Haltech Elite 2500 ECU has Dual CAN Bus communications capable of communicating directly to the Haltech Bus and the Vehicle Bus and can be enabled and configured via the Devices tab within the setup page.
Auxiliary CAN Bus Port
The Auxiliary CAN Bus Port is designed to be used with a standard Deutsch DTM Series 4 pin connector. This port can be setup to broadcast Haltech CAN data or Vehicle Bus data. Pre-Terminated cables can be purchased to connect to the CAN Bus Port. ...
Auxiliary USB Port
The Auxiliary USB Port (type A) is reserved for future expansion.
Communications USB Port
Connect the supplied USB cable (type B) to this port to program the ECU with the connected computer and supplied Elite Software Programmer, in real time.
Power LED
The Power LED shows the ECU's power and running status by displaying different colours and flashing sequences. Power LED descriptions are listed in the table below. Colour Flashing Sequence Description Off Solid No Power Red Solid System Error White ...
Status LED
The Status LED indicates the current status of the ECU by displaying different colours and flashing sequences. Status descriptions are listed in the table below. Colour Flashing Sequence Description Off Solid No Power to ECU Or Normal Operation Red ...
Tools and Materials that you may need
Installation of this system can be easily carried out by professional mechanic(s) and most experienced home mechanics if some basic tools and components are available: Voltmeter or Test Light A selection of screwdrivers and spanners Soldering Iron ...
Before You Begin
PLEASE READ THIS ENTIRE MANUAL BEFORE STARTING. At the very least, you should read the wiring and installation section of the manual before you begin wiring. The greater your knowledge of the operation of the Haltech system, the easier you will find ...