Ford Falcon I6 Barra - Installation Guide
Status LED
The Status LED indicates the current status of the ECU by displaying different colours and flashing sequences. Status descriptions are listed in the table below. Colour Flashing Sequence Description Off Solid No Power to ECU or Normal Operation Red ...
Power LED
The Power LED shows the ECU's power and running status by displaying different colours and flashing sequences. Power LED descriptions are listed in the table below. Colour Flashing Sequence Description Off Solid No Power Red Solid System Error White ...
ABS Module - Installation Status for Transmission swaps
This feature will allow automatic shifting of the ZF transmission without a factory ABS module present, such as when the ZF transmission has been used in a vehicle conversion. This feature may not fully replicate factory behaviour in every ...
FG MkI Radio Reprogramming
Using the supplied Elite Pro Plug-in DTM4 CAN to OBDII Radio Reprogramming Cable (HT-135001), a once off reprogramming of the radio module in Ford Falcon FG MkI Models (2008-2011) can be performed to re-enable full functionality when the OEM ECU is ...
Vehicle CAN Support
BA The Ford Falcon Elite Pro Plug-in has extensive BA 6 cylinder Falcon CAN support integrated into the software. Once the initial setup is done, the Haltech Pro Plug-in will interface with all modules within the vehicle. Some of the functions ...
FG Pinout Information
Pin Function A01 - A02 Park/Neutral Switch Input A03 Injector 6 Output A04 Injector 4 Output A05 Cam Control - Intake Solenoid A06 Cam Control - Exhaust Solenoid A07 Injector 2 Output A08 Injector 5 Output A09 Narrowband Heater 2 Output (Post-Cat) ...
BF Pinout Information
Pin Function A01 - A02 PCS - Power Control Solenoid (4 Speed Auto - Not Currently Supported) A03 Injector 6 Output A04 Injector 4 Output A05 Cam Control - Intake Solenoid A06 Cam Control - Exhaust Solenoid A07 Injector 2 Output A08 Injector 5 Output ...
BA Pinout Information
Pin Function A01 - A02 PCS - Power Control Solenoid (4 Speed Auto - Not Currently Supported) A03 Injector 6 Output A04 Injector 4 Output A05 Cam Control - Intake Solenoid A06 Cam Control - Exhaust Solenoid A07 Injector 2 Output A08 Injector 5 ...
Plug-in Model Selection
Plug-in Information Model Setup Some factory pin locations and functionality vary between vehicle variants. Upon making a Plug-In Information "Model" selection (referenced in Initial ECU Setup), the hardware configuration is set and the on-board ...
Initial ECU Setup
Your Elite Pro Plug-in Series ECU has been shipped in a default state. It will NOT start your vehicle without ESP configuration. Please follow the steps below to ensure you upload the correct map, set your vehicle variant and calibrate your ...
Before You Begin
Warning This product is pre-configured to operate on a standard un-modified vehicle. If your vehicle has modifications that are not standard, then please take the time to read the manual and familiarise yourself with any potential software changes ...